Honeywell Home VisionPRO 8000 Manual page 19

Wireless Indoor Sensor
1. Press and quickly release the CONNECT button. After
a short delay, the status light (see Fig. 51) will glow
green for 15 seconds. If the status light turns red, the
sensor did not link with the thermostat.
MCR32934
Fig. 51. Wireless indoor sensor connect button and
status light.
NOTE: In normal operation, the status light remains
off. If it begins flashing red, batteries are low
(power will be depleted after 2–3 weeks).
2. After a short delay (up to 15 seconds), check thermo-
stat to confirm the connection of the sensor.
Fig. 52.
3. If you are installing more than 1 wireless indoor sen-
sor, give each sensor a name as you install it. Press
Yes when the "Rename Indoor Sensor?" screen is dis-
played, as shown in Fig. 53.
Fig. 53.
4. Select the Indoor Sensor name from the list and press
Done. The Indoor Sensor names are used when
selecting which sensor to use for temperature con-
trol, humidification control, and dehumidification
control.
MCR32935
NOTE: If you link more than 1 wireless indoor sen-
Entry/Exit Remote or Vent Boost Remote
1. Press and quickly release the CONNECT button.
Fig. 56. Connect button and status light on Entry/Exit
2. After a short delay, the status light will glow green for
15 seconds. If the status light turns red, the remote
did not link with the thermostat for the connection
process.
NOTE: The thermostat can work with up to 3 Entry/Exit
remotes. Each Entry/Exit remote can control up to
16 thermostats.
19
®
VISIONPRO 8000 WITH REDLINK™
Fig. 54.
sor, and forget to name them, you will be
prompted to name each wireless indoor sen-
sor after you exit wireless setup. See Fig. 55.
Fig. 55.
MCR33096
Remote or Vent Boost Remote.
68-0312—06