Honeywell Home VisionPRO 8000 Manual page 54

®
VISIONPRO 8000 WITH REDLINK™
ISU Installer Setup
Number Name
Off
1013 High Outdoor Temp
Vent Lockout 80° F to 110° F (in 5° F
increments)
Off
1013 High Out. Dew Point
Vent Lockout 65° F to 85° F (in 5° F increments)
Yes
1014 Vent During Hum or
Dehum Calls No
Off
1016 Vent On High
Indoor Humidity On
Off
1017 Ventilator Core
Reminder 3, 6, 9, 12 Calendar Months
Off
1017 Ventilator Filter
3, 6, 9, 12 Calendar Months
Reminder
0, 1, 2
1100 Number of UV
Devices
Off, 6, 12, 24 Calendar Months
1105 UV Bulb 1 Reminder
Note: "1" is not
displayed if there is
only 1 UV Bulb
Off, 6, 12, 24 Calendar Months
1105 UV Bulb 2 Reminder
View / Edit Custom Reminders
1200 Custom Reminders
Add Custom Reminders
68-0312—06
Table 3. Installer Setup (ISU) Table. (Continued)
Settings Default
Off
Off
Yes
On
Off
Off
0
Off
Off
None
Residential,
Commercial Requires
or Both EIM
Both No
Both No
Both No
Both No
Both No
Both No
Both No
Both No
Both No
Both No
54
Notes
Requires an outdoor sensor.
This ISU is only displayed when ISU 1000
Ventilation Type is set to ERV / HRV or Fresh Air
Damper.
See "Ventilation — Outdoor Condition Lockouts
(ISU 1013)" beginning on page 93.
Requires a Wireless Outdoor Sensor (sense
outdoor humidity).
This ISU is only displayed when ISU 1000
Ventilation Type is set to ERV / HRV or Fresh Air
Damper.
See "Ventilation — Outdoor Condition Lockouts
(ISU 1013)" beginning on page 93.
This feature is used to help reach the user's desired
humidity level by not allowing the ventilation
equipment to run during a call for humidification
or dehumidification.
Yes: Ventilation is allowed to run during a call for
humidification or dehumidification.
No: Ventilation is NOT allowed to run during a call
for humidification or dehumidification.
This ISU is only displayed when ISU 1000
Ventilation Type is set to ERV / HRV.
Off: The humidity level has no effect on
ventilation.
On: The thermostat removes excess humidity by
turning on the ventilator when the indoor humidity
rises 10% above the user's humidification setting.
The thermostat must be in the heat mode to
ventilate on high humidity.
Ventilator Core Cleaning Reminder
Ventilator Filter Cleaning Reminder
Press the up/down arrows to select the number of
UV devices installed in the system. Some systems
may have two UV devices, one for the A-Coil and
another for Air Treatment. A replacement reminder
can be setup for each one. Select 0 if no UV devices
are installed.
UV Bulb 1 Replacement Reminder
UV Bulb 2 Replacement Reminder
See "Customizable Reminders" beginning on
page 98.