Honeywell Home VisionPRO 8000 Manual page 55

ISU Installer Setup
Number Name
On Demand
28 Backlighting
Continuous
12 hour
1400 Clock Format
24 hour
Off
1401 Daylight Saving
On
Time
-3° F to 3° F (in 1° F increments)
1402 Indoor Temperature
Offset
-12% to 12% (in 1% increments)
1402 Indoor Humidity
Offset
On
1404 Alert Light Indicator
Off
[Dealer Name]
1500 Dealer Name
[Dealer Phone]
1500 Dealer Phone
[Dealer Email Address]
1501 Dealer Email
Address
[Dealer Website]
1501 Dealer Website
[Dealer Message]
1502 Dealer Message
Table 3. Installer Setup (ISU) Table. (Continued)
Settings Default
On Demand
12
On
0° F
0%
On
None
None
None
None
None
55
VISIONPRO
Residential,
Commercial Requires
or Both EIM
Both No Select Continuous or On Demand backlighting.
Select Continuous backlighting if you would like
the backlight to be on all the time (C wire is
required for Continuous backlighting).
Select On Demand backlighting if you would like
the backlight to only turn on after a key press. After
you complete your changes, the screen stays lit for
16 seconds if the thermostat is battery powered
only or it stays lit for 45 seconds if the thermostat
is system powered (C wire).
Both No
Both No Set to Off in areas that do not follow Daylight
Saving Time.
Both No 0° F - No difference in displayed temperature and
the actual room temperature.
The thermostat displays up to 3°F (1.5°C) lower or
higher than the actual measured temperature.
Both No 0% - No difference in displayed humidity and the
actual room humidity.
The thermostat displays up to 12% lower or higher
than the actual measured humidity.
Both No The thermostat has a built in light indicator. When
an alert is active, the light will be on continuous if
the thermostat is powered with 24 VAC (C wire) or
it will flash if the thermostat is powered with
batteries only. The light also turns on when the
system setting is set to Em Heat.
Select On to use the light indicator or select Off to
turn off the light.
Both No Dealer information is displayed to the user when
an alert is active and the user can access this
Both No
information by selecting "Dealer Information" in
Both No
the Menu.
Both No
Both No
®
8000 WITH REDLINK™
Notes
68-0312—06