Using The Wireless Signal Strength Test; Mounting Optional Accessories - Honeywell Home VisionPRO 8000 Manual

Using the Wireless Signal Strength
Test
1. Select Installer Test (see Fig. 64), then select Wireless
Test.
Fig. 69.
2. Press Next to measure the signal strength. After a
brief pause, the thermostat will display test results.
3. A number from 5-10 means communication is good.
Fig. 70.
4. If the screen displays "No Signal," move the thermo-
stat to a different location and test again.
Fig. 71.
MOUNTING OPTIONAL
ACCESSORIES
Outdoor Sensor
Mount the sensor where:
• it cannot be tampered with.
• there is good air circulation.
• it can measure true outdoor ambient temperature and
humidity.
• wire distance between C7089U1006 and
thermostat/EIM is less than 200 feet (wired sensor
only).
Do not mount the sensor:
• in direct sunlight.
• where hot or cold air blows on the sensor. Discharge line
from an outdoor compressor unit, vent or fan causes
inaccurate temperature readings.
• where snow, ice or debris can cover it.
MOUNTING C7089R1013 WIRELESS OUTDOOR
SENSOR
Use the following steps to mount the sensor (see Fig. 72):
1. Mount the sensor on a vertical exterior wall, at least 6
inches below any overhang. Choose a location pro-
tected from direct sunlight.
2. Place sensor securely in bracket, facing away from
wall.
Fig. 72. Mounting Outdoor Sensor.
MOUNTING C7089U1006 WIRED OUTDOOR
TEMPERATURE SENSOR
Use the following steps to mount the sensor:
1. Remove the sensor from the mounting clip.
2. Mark the area on the location selected for mounting
the sensor mounting clip.
3. Mount the clip.
4. See "Wiring C7089U1006 Outdoor Sensor" on
page 136.
57
®
VISIONPRO 8000 WITH REDLINK™
M28491
68-0312—06