Honeywell Home VisionPRO 8000 Manual page 110

®
VISIONPRO 8000 WITH REDLINK™
Portable Comfort Control
78
SET TO
78
REPLACE
BATTERY
Install fresh batteries when the REPLACE BATTERY
warning begins flashing. The warning flashes about 60
days before batteries are depleted.
The Portable Comfort Control will restore communication
with the thermostat a few seconds after new batteries are
installed.
Wireless Outdoor Sensor
Replace batteries in your outdoor sensor when a warning
appears on the thermostat screen, about 60 days before
batteries are depleted.
Outdoor Sensor
has low batteries
Fig. 300.
To replace the batteries:
1. Remove the sensor from the bracket.
2. Detach cover.
3. Install 2 fresh AA lithium batteries.
4. Replace cover and set sensor back into bracket.
The outdoor sensor will restore communication with the
thermostat a few seconds after new batteries are installed.
M32988
68-0312—06
M28896
MCR28475
MCR34145
MCR32937
Wireless Indoor Sensor
Replace batteries in your indoor sensor when a warning
appears on the thermostat screen, about 60 days before
batteries are depleted.
When the sensor status light begins flashing red, battery
power is critically low and will be depleted within 2–3
weeks. During normal operation, the status light remains
off.
Indoor Sensor
has low batteries
To replace the batteries:
1. Remove the sensor from wallplate.
2. Install 2 fresh AAA alkaline batteries. If the status
light flashes green, batteries are good; if it flashes
red, you must use fresh batteries.
3. Attach sensor to wallplate.
The sensor will restore communication with the thermostat
a few seconds after new batteries are installed.
M32990
110
MCR34146
Fig. 301.
MCR32933