Honeywell Home VisionPRO 8000 Manual page 58

®
VISIONPRO 8000 WITH REDLINK™
Fig. 73. Typical locations for C7089U1006 Outdoor
Sensor.
C7189R1004 Wireless Indoor Sensor
Use the following steps to mount the sensor (see Fig. 74):
1. Remove the wallplate and mount it 4 to 6 feet above
the floor on an interior wall. Drill 3/16-inch holes for
drywall, 7/32-inch for plaster.
2. Attach sensor securely to wallplate as shown.
Fig. 74. Mounting Indoor Sensor.
68-0312—06
C7189U1005 Wired Indoor Sensor
Use the following steps to mount the sensor:
1. Remove the cover from the remote sensor (see
Fig. 75).
M7514
2. Pull wires through wire hole.
3. Position wallplate on wall, level and mark screw hole
positions with pencil.
4. Drill holes at marked positions, then tap in supplied
wall anchors.
5. Place wallplate over anchors, insert and tighten
mounting screws (see Fig. 76).
6. Replace the cover on the remote sensor.
58
U P
Fig. 75. Remove the cover.
M24057
Fig. 76. Mount wallplate to wall.
M24056A