Locating The Connect Buttons On Redlink Accessories - Honeywell Home VisionPRO 8000 Manual

4. Select Wireless Manager.
Wireless Manager
Reset To Defaults
Fig. 41.
5. Select Add Device. The screen displays "Press Con-
nect on New Accessories." The thermostat is now in
listening mode.
Add Device
Connected Devices
Fig. 42.
NOTE: Accessories must be at least 2 feet away from the
thermostat or EIM during the linking process.
6. Press and quickly release the CONNECT button on
each new RedLINK accessory.
NOTE: For locations of CONNECT buttons on
RedLINK accessories, see "Locating the
Connect Buttons on RedLINK Accessories"
beginning on page 17.
Press Connect on
New Accessories.
Fig. 43. Thermostat in listening mode.
7. After a short delay (up to 15 seconds), check thermo-
8. Touch Done at the thermostat after all new RedLINK
MCR33980
NOTE: Thermostat displays a count-down timer while in
Locating the Connect Buttons on
RedLINK Accessories
MCR33981
Wireless Outdoor Sensor
1. Press and quickly release the CONNECT button on
Fig. 45. Wireless outdoor sensor connect button.
Portable Comfort Control
1. Press CONNECT on the Portable Comfort Control
MCR34058
Fig. 46. Portable Comfort Control connect button.
2. Press DONE on the Portable Comfort Control when it
17
VISIONPRO
stat to confirm the connection of each RedLINK
 or
accessory. Touch to review the list.
accessories are connected.
Outdoor Sensor
has been added
Fig. 44.
the listening mode. If it detects no activity for 15
minutes, it exits listening mode.
the Wireless Outdoor Sensor. After a short delay (up
to 15 seconds), the thermostat will display "Outdoor
Sensor has been added."
display screen.
WIRELESS SETUP
displays "Connected."
®
8000 WITH REDLINK™
MCR33972
CONNECT
MCR32942
68-0312—06