Honeywell Home VisionPRO 8000 Manual page 18

®
VISIONPRO 8000 WITH REDLINK™
3. Press "No" at the next screen to save and exit, or press
"Yes" if you need to connect additional thermostats to
the Portable Comfort Control. See Fig. 47.
NOTE: The Portable Comfort Control can control up to 16
thermostats.
YES
CONNECT MORE?
Fig. 47. Connect additional thermostats to Portable
Comfort Control.
4. Follow the same linking procedure as above to con-
nect additional thermostats.
ERROR MESSAGES:
E1 29: Incompatible device cannot be connected.
E1 34: Low RF signal. Move device to a different location
and try again.
E1 38: Make sure the thermostat, EIM, or TrueZONE
Wireless Adapter is in Wireless Setup mode, and the
Portable Comfort Control is at least 2 feet away (600 mm).
NOTE: The linking procedure will time out if there is no
keypress for 30 minutes. To begin again, press and
hold in the lower right corner of the screen until
the display changes (about 3 seconds). See
Fig. 48.
Fig. 48. Restarting the linking process.
68-0312—06
NO
M28482
Press and hold
the blank space
(or arrow may be
present)
RedLINK Internet Gateway
1. Press and quickly release the button on the Internet
Gateway. After a short delay, the RedLINK status light
will glow steady green.
Fig. 49. RedLINK Internet Gateway connect button.
NOTE: The Internet Gateway must be registered online
before use at www.mytotalconnectcomfort.com.
Enter the MAC ID and MAC CRC numbers located
on the bottom of the Internet Gateway. For addi-
tional information, see instructions provided with
the device.
TrueSTEAM
1. Press and quickly release the CONNECT button on
THM4000 Wireless Adapter. After a short delay, the
CONNECTED status light will glow steady green.
THM4000R1000
Fig. 50. Connect button on TrueSTEAM wireless adapter.
18
M36571A
TrueSTEAM
MCR34523A