Operation - Honeywell Home VisionPRO 8000 Manual

Entry/Exit Remote or Vent Boost Remote
Mounting the remote is optional.
1. Remove the front cover from the remote.
2. Use provided screws and wall anchors to fasten the
remote to the wall. Drill 3/16-inch holes for drywall,
7/32-inch for plaster.
Fig. 77. Mounting Entry/Exit Remote or Vent Boost
Remote.
3. Replace the cover on the remote.

OPERATION

NOTE: The screen lights when you press any button. After you complete your changes, the screen stays lit for 16 seconds
if the thermostat is battery powered only or it stays lit for 45 seconds if the thermostat is system powered (C wire).
Depending on how your thermostat was installed, the screen light may always be on.
M33095
Fig. 78. Quick reference to residential display.
59
VISIONPRO
HOME. Touch to display Home screen.
FAN. Select fan mode.
SYSTEM. Select system mode (Heat/Cool).
MENU. Touch to display options. Start here to
set a program schedule.
Current status. Shows system mode (heat/cool),
outdoor temperature and humidity (with
optional outdoor sensor).
Current schedule. Touch an arrow to change
temperature setting and select a Temporary or
Permanent Hold.
Indoor conditions. Shows indoor temperature
and humidity.
Current time. Touch to set the current time/date.
Alert Light. On when alert message is active or
system is set to EmHeat. Flashes for battery-
only power; on continuous if system powered.
®
8000 WITH REDLINK™
68-0312—06