Linking Thermostat To Equipment Interface Module (If Used); Linking Redlink Accessories - Honeywell Home VisionPRO 8000 Manual

1. Follow prompts on the screen to select the appropri-
ate options.
APPLICATION
residential
Fig. 29. Select application (residential or commercial).
NOTE: If you are connecting the thermostat to the True-
ZONE Wireless Adapter (THM4000), refer to the
TrueZONE instructions to link the thermostat and
RedLINK accessories.
Linking Thermostat to Equipment
Interface Module (if used)
1. In thermostat setup, when you are prompted to
answer TSTAT CONTROLS AN EQUIP. MODULE:
select yes, then press Next.
Fig. 30.
2. Press and quickly release the CONNECT button on
the EIM. Make sure the "Connected" light is flashing
green.
C O N N E C
Fig. 31. EIM CONNECT button.
NOTE: If the "Connected" light does NOT flash
green, another system may be in the listen-
ing mode. Please exit the listening mode at
the other system and then try again.
CO NN EC
TE D
T
Green Flashing: In Listening Mode - system
is ready to add RedLINK devices.
Green Steady: RedLINK devices are commu-
nicating.
Red: RedLINK device(s) are NOT communi-
cating. Check EIM and RedLINK devices.
3. While the "Connected" light is flashing green on the
EIM, press Next on the thermostat. After a short
delay, the screen will show the thermostat is con-
nected.
4. Press Next, as directed on screen, to link RedLINK
accessories.

Linking RedLINK Accessories

1. When you see the prompt Connect RedLINK Accesso-
ries?, touch No or Yes.
a. If you select No, continue to step 5.
b. If you select Yes, you will be prompted to Press
Connect on New Accessories. Continue to step 2.
Connect RedLINK
Accessories?
Fig. 34. Connect RedLINK accessories.
NOTE: Accessories must be at least 2 feet away from the
thermostat or EIM during the linking process.
2. While the Press Connect message is displayed (lis-
tening mode), press and quickly release the CON-
NECT button on each new RedLINK accessory.
NOTE: For locations of CONNECT buttons on
RedLINK accessories, see "Locating the
Connect Buttons on RedLINK Accessories"
15
®
VISIONPRO 8000 WITH REDLINK™
Fig. 32.
Fig. 33.
MCR33970
68-0312—06