Table of Contents
Advertisement
®
VISIONPRO
8000 WITH REDLINK™
Portable Comfort Control
1. Install 3 fresh AA alkaline batteries.
Fig. 24.
Indoor air sensor
1. Install 2 fresh AAA alkaline batteries.
Fig. 25.
RedLINK™ Internet Gateway
1. Connect power cord to an electrical outlet not con-
trolled by a wall switch.
2. Connect ethernet cable to router and the RedLINK
Internet Gateway.
Fig. 26.
68-0312—06
MCR32939
MCR32938
M36568
TrueSTEAM (Obsolete)
1. Wire and power TrueSTEAM.
2. Connect the ABCD terminals between TrueSTEAM
and the THM4000 Wireless Adapter.
3. Adjust the DIP Switches on TrueSTEAM as follows
when using the Wireless Adapter:
• DIP3: UP
• DIP4: UP
• DIP5: DOWN
THM4000R1000
Fig. 27. Powering TrueSTEAM wireless adapter.
Entry/Exit Remote or Vent Boost Remote
1. Remove the cover.
2. Insert the CR2450 coin cell battery (included) into
the slot at the bottom of the remote. See polarity
marking on the remote.
Fig. 28. Installing Entry/Exit Remote or Vent Boost
Remote battery.
3. The LED will briefly flash green. If it flashes red, bat-
tery is not good.
PERFORMING INITIAL SETUP
NOTE: If the thermostat is wired directly to the equip-
ment, 24 VAC (C wire) is required to connect
RedLINK accessories. Turn on 24 VAC before per-
forming the initial setup.
Initial setup options define the type of system you are
installing:
• Residential or commercial
• Non-zoned or zoned
• Used with or without an Equipment Interface Module
(THM5421)
• Used with or without the TrueZONE Wireless Adapter
(THM4000)
14
TrueSTEAM
MCR38036
MCR33269
Hide quick links:
Advertisement
Table of Contents
