Wi-Fi Setup, After Initial Installation; Scheduling And Geofencing - Honeywell Home T10 Pro RedLINK Manual

Connect to a hidden Wi-Fi
1. Touch MENU, then Wi-Fi Setup.
2. Touch Other, then Select.
3. When prompted, press the screen to edit the network
name.
4. Enter the network name.
 
Press the or buttons to change the letter or
number. Press the
character, or the

character. Use the
change letter case. Press Done when complete.
5. Select the appropriate network security setting, then
press Select.
6. Enter the Wi-Fi network password as explained
above in "Connecting to Wi-Fi Network", step 6.
Unsuccessful Wi-Fi connection
If you are unsuccessful in connecting the thermostat to
the Wi-Fi network, you will see a Connection Failed screen.

Press button for other tips about this failed connection.
Here are three specific reasons the connection might be
unsuccessful.
For all Connection Failed screens, pressing Done will
return to the Menu screen.
Invalid Password
The password you entered is invalid. Check that you have
the right password and try again.
No IP Address
The thermostat was unable to obtain an IP address from
the router. Verify the router is correctly set up to
automatically assign IP addresses. This connection can
take several minutes. If there is still no connection, remove
the thermostat from the wallplate for 10 seconds, then
snap it back into place.
No Internet Link
The thermostat connected to the Wi-Fi network but was
unable to establish a connection to the internet. Check the
router settings and try again. Make sure the Ethernet
cable is plugged into the router and try rebooting the
router if necessary.
®
network
button to move to the next
button to move to the previous

or buttons at the bottom to
T10 PRO SMART THERMOSTAT WITH REDLINK

Wi-Fi setup, after initial installation

During the initial installation, after the Installer setup the
thermostat will prompt you to set up Wi-Fi and guide you
through the steps. if you are setting up Wi-Fi after the
initial installation has already been done, follow the below
steps:
1. Select the main menu icon
2. Then select Configuration - Wi-Fi
3. There is a slider labeled "Enable Wi-Fi". Make sure
this is set to the right.
4. Touch "Choose Network".
5. After a brief delay, the thermostat should show the
available networks. Choose your home network from
the list.
6. If this is a secure network, it should prompt you to
"Enter Wi-Fi password". After a brief delay the dis-
play should show "Success! Your thermostat suc-
cessfully connected to the network." Press the "OK"
button.
NOTE: if you did not successfully connect to the network,
attempt to-

Scheduling and Geofencing

Time-based scheduling setup on thermostat-
• From Homescreen, Select Menu-Schedule.
• Select "Grouped days" if you want the same schedule
for all days.
• Select "Single Days" if you want 7 day scheduling.
• Select "Schedule Options"- Create New Schedule" to
get additional option for 5-2 Scheduling.
29
Fig. 43.
33-00462—01