Removing And Installing Interior Monitoring Deactivation Switch E 267 And Deactivation Button For Vehicle Inclination Sender E; Removing And Installing The Rear Seat Heating Switch - Skoda Octavia III 2013 Workshop Manual

2.7 Removing and installing interior moni‐
toring deactivation switch -E 267- and
deactivation button for vehicle inclina‐
tion sender -E 360-
Removing
– Switch off the ignition and all electrical components.
– Loosen the top part of the B-column trim panel at the bottom
-1- on the driver side⇒ Body Work; Rep. gr. 70 and tilt slightly.
– Push switch -2- out of the trim panel -1-.
– Disconnect plug.
Installing
Installation is carried out in the reverse sequence.
2.8 Removing and installing the rear seat
heating switch
Caution
When using the lever tool, mask points where the lever tool is
applied using commercially available adhesive tape.
– Switch off the ignition and all electrical components.
– Lever off the cover -2- using the removal wedge - 3409-
-arrow-.
– Unplug connector -1-.
– Push switch -1- from behind -arrow- out of the cover -2-.
– Installation is carried out in the reverse sequence.
Octavia III 2013 ➤ , Octavia III 2014 ➤
Electrical system - Edition 12.2014
2. Interior switches, in the dash panel, the centre console and the doors
157