Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
The figure shows the gearbox from the rear. -P- position is in the
direction towards the cable support -arrow-.
– Turn both front wheels in one direction, e.g. by rolling the ve‐
hicle forwards, until the parking lock in the gearbox engages
into the parking gear.
•
Only if both front wheels cannot be simultaneously turned in
one direction, the parking lock is engaged.
– Slightly move the selector lever towards the front and rear,
without shifting into another selector lever position.
Note
The selector lever control cable is therefore released.
– Tighten screw -arrow- at selector lever cable without jolting to
tightening torque.
Note
Pay attention when tightening the screw -arrow- that the selector
lever control cable no longer shifts.
– Install air filter ⇒ Engine; Rep. gr. 24 or ⇒ Engine; Rep. gr.
23 .
Specified torques
Component
Screw for selector lev‐
er control cable (Octa‐
via II, Superb II and
Yeti)
♦ up to 11.2008
Screw for selector lev‐
er control cable (Octa‐
via II, Superb II and
Yeti)
♦ from 12.2008
Screw for selector lev‐
er control cable (Fabia
II, Roomster and Rapid
NH)
2.4
Check the function of the ignition key re‐
moval lock
– Turn the ignition key slightly to the right (do not start the en‐
gine) in order to set the position "ignition on".
– Depress brake pedal and hold pressed.
•
Shifting the selector lever out of the position P when the lock
button is pressed at the grip of the selector lever must be pos‐
sible without jerking.
– Switch off ignition.
•
The ignition key should only be removable when the selector
lever is in P.
108
Rep. gr.34 - Controls, housing
Nm
13
12
12