Skoda FABIA II 2007 Workshop Manual page 1188

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
Caution
– Pull the locking tab -3-, which secures the bolt -4-, carefully in
the -direction of arrow A-.
– Insert the screwdriver into the right opening of the shift mech‐
anism, as shown, and press on the bolt.
– Remove lock washer -5-.
– Remove selector lever control cable.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
♦ Inspect boot of selector lever control cable for damage; the
boot can only be replaced together with the selector lever con‐
trol cable.
♦ Check correct fitting of the boot and do not install the boot
twisted.
Do not grease ball socket of the selector lever control cable and
ball head/selector lever.
Caution
♦ Under no circumstances touch the circuit board of the
gearshift mechanism with the fingers, because static dis‐
charge can destroy the electrical components and the
circuit board.
♦ The circuit board can only be replaced together with the
gearshift mechanism!
– Insert the selector lever control cable with protective cover into
the shift housing. Do not damage the boot.
– Insert the end of the selector lever control cable -4- into the
joint of the selector lever.
– Press bolt -3- downwards in -direction of arrow- and check if
the locking tab -2- is locked.
– Insert the lock washer -1- for the selector lever control cable.
• Fitting position: angled end towards the gearshift mechanism.
126
Rep. gr.34 - Controls, housing