Configure The Controller - Mitel 3300 ICP Hardware User's Manual

Install DSP Modules
CAUTION: To prevent ESD damage while handling modules on any unit, always attach
the wrist strap from the cabinet being serviced, and immediately place any item removed
from a cabinet into an anti-static bag.
CAUTION: Do not drop screws or lock washers in the controller.
To install the DSP Module:
1. Remove the cover from the 3300 ICP Controller.
2. Remove the DSP Module from the packaging and ensure that it is complete.
3. Line up the connectors module and firmly seat onto the board.
Note: Refer to the configurations for placement of the DSP.
4. Secure the module onto the board using the screws and lock washers provided.
5. Replace the 3300 ICP cover.

Configure the Controller

Note: Before you begin, you should review the LAN and WAN guidelines and plan the
network. Complete the Installation Planner. You will need to know the IP addresses
reserved by the customer for the 3300 ICP Controller (one for the RTC and one for the
E2T for the 250 user/700 user controllers, one for the 100 user controller) and for the IP
Phones.
Tip: The initial power-up and the reset in this procedure will each take 15 to 20 minutes.
Release 3.3
Installing
123