Linear Encoder Manufactured By Mitutoyo (Absolute Position Type); At343A - Mitsubishi Electric MELSERVO-JET MR-JET Series User Manual

*1 The values shown in this table are the manufacturer specification values. When the linear encoder is used with the MELSERVO-JET
series servo amplifiers, the specification value is the lowest value of either the value indicated in the table or the rated speed of the servo
motor.
*2 The values shown in this table are the manufacturer specification values. The length of the encoder cable between the linear encoder
and the servo amplifier should not exceed 30 m.
*3 Select a linear encoder that has a resolution within this range.
1.3
Linear encoder manufactured by Mitutoyo
(absolute position type)
The absolute position battery is not required when constructing an absolute position detection system.

AT343A

Cable structure
Prepare a cable based on the following configuration diagram.
■For the linear servo motor
Servo amplifier
CN2
Conditions
When using an optional encoder cable
When fabricating an encoder cable
*1 These items should be prepared by the customer.
Encoder cable
(1)
(2)
Encoder cable
(1) MR-EKCBL_M-H
2 m/5 m
Page 38 MR-EKCBL_M-H encoder cable
(2) MR-ECNM connector set
Page 8 Encoder cable

1.3 Linear encoder manufactured by Mitutoyo (absolute position type)

Linear encoder
AT343A
(3)
Output cable
(3) Options manufactured by Mitutoyo
Part No.09BAA598A: 0.2 m
Part No.09BAA598B: 2 m
Part No.09BAA598C: 3 m
1 LINEAR ENCODER
1
*1
7