Response Code (Sdo Abort Code) - Mitsubishi Electric MELSEC iQ-F FX5 Series User Manual

Event Description
code
00C81 CC-Link IE TSN Class setting mismatch
8.8

Response Code (SDO Abort Code)

The following shows the response code when the send/receive error occurred in the object data using the PDO mapping and
transient transmission function.
SDO Abort Code Description
0601 0000h An unsupported object was accessed.
0601 0001h A write-only object was accessed for reading.
0601 0002h A read-only object was accessed for writing.
0602 0000h An object that is not defined in the object dictionary was accessed.
0604 0041h An object not permitted for PDO mapping was mapped.
0604 0042h The number of data or data length total for PDO mapping exceeds the value defined in
the application, etc.
0607 0010h The accessed object data size does not match the specified data size at request.
0607 0012h
0607 0013h
0609 0011h A SubIndex that does not exist was specified.
0609 0030h An invalid parameter value was set.
0609 0031h A value larger than the parameter range was set.
0609 0032h A value smaller than the parameter range was set.
0800 0020h The application cannot transmit or store the data.
Cause
A mismatch was detected between the parameter of the master station and "CC-Link IE
TSN Class Setting" of the device stations.
8.8 Response Code (SDO Abort Code)
Remedy
Revise the Index and subIndex.
Revise the data for PDO mapping.
Revise the specified value for object
size.
Revise the Index and subIndex.
Revise the data value.
Check the status of the target device.
8 TROUBLESHOOTING
8
167