6. If disassembled install the H-springs in the roller cage
assembly.
7. Place the cage in the housing and carefully install
q
each roller
.
8. Lower the roll cage assembly into the inner ring gear /
roller cage housing while installing the rollers to
prevent them from falling out of the roller cage.
NOTICE
Install roll cage so that the ring gear grooves line up
with the roll cage windows.
9850045 R01 - 2020-2021 RANGER 1000 Service Manual
© Copyright Polaris Inc.
r
9. Install the torsion spring
the spring around the dowel pin on the ring gear.
10. Align spring retainer dowel pin with ring gear dowel
pin and install the retainer on top of the torsion spring.
11. Check the action of the torsion spring by rotating in
both directions to ensure the spring and retainer are
installed properly.
FINAL DRIVE
by wrapping each leg of
8.37
8