Polaris RANGER 1000 2020 Service Manual page 103

Hide thumbs Also See for RANGER 1000 2020:
Table of Contents

Advertisement

ITEM
XU / D Brake Pads / Parking Brake Pads (INT'L) Inspect pad wear; replace if worn beyond service limit
EVAP System
D / E
Fuel System
D / E
XU / D Parking Brake Cable Adjustment (INT'L)
Engine Breather
XU / E
Battery
XU
General Lubrication
D / E
Throttle Pedal
Throttle Body Intake Ducts/Flange
E
Shift Cable / Linkage
Steering
D
Front / Rear Suspension
XU
Cooling System
D
D
Drive Belt
XU / D Clutches (Drive and Driven)
Engine Oil Lines/Fasteners
XU
Engine Oil & Filter Change
XU / E
XU
Front Gearcase Lubricant
Transmission Lubricant (AGL)
XU
Spark Plug Inspection
D / E
XU
Radiator
Cooling Hoses
XU
Engine Mounts
XU
Exhaust Silencer / Pipe
Wiring
XU
Front Wheel Bearings
D
XU / D Shocks
D
Brake Fluid
Spark Arrestor
Cam Chain Tensioner
D / E
Valve Clearance
XU - Perform these procedures more often for vehicles subjected to severe use.
D - Have an authorized Polaris dealer perform these services.
E - Emission Control System Service (California)
9850045 R01 - 2020-2021 RANGER 1000 Service Manual
© Copyright Polaris Inc.
200 HOUR / 2000 MILE (3200 KM) SERVICE
REMARKS
Inspect Fuel and EVAP system if equipped.
Turn key on to pressurize fuel pump; check lines / fittings for leaks and
abrasion. Replace as needed.
Inspect; adjust tension after first 25 hours
Inspect; clean
Check terminals; clean; test
Lubricate all fittings, pivots, cables, etc.
Inspect; replace if it sticks
Inspect ducts for proper sealing / air leaks
Inspect; adjust as needed
Lubricate (if applicable)
Lubricate (if applicable)
Inspect coolant strength seasonally; pressure test system yearly
Inspect; replace as needed
Inspect; clean; replace worn parts
Inspect for leaks and loose fittings
Change oil and filter, inspect used oil for contaminants
Change lubricant
Change lubricant
Inspect; replace as needed; torque to specification
Inspect; clean external surfaces
Inspect for leaks; pressure test system
Inspect, torque to specification
Inspect
Inspect routing and for wear; inspect connectors subjected to water/mud.
Inspect; replace as needed
Change shock oil and inspect seals
Change every two years (DOT 4)
Clean daily if driven in mud / water; replace a damaged arrestor before
operating
Inspect/clean; replace as needed
Inspect; adjust as needed
MAINTENANCE
2
2.15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ranger 1000 2021

Table of Contents