Water Pump Service - Polaris RANGER 1000 2020 Service Manual

Hide thumbs Also See for RANGER 1000 2020:
Table of Contents

Advertisement

8. Lift the cover from the housing and remove the
thermostat.
NOTICE
Thermostat has a pop-off relief to allow the bypass
system to operate until thermostat opens.
9. Install a new thermostat.
10. Reverse this procedure for installation. Torque
thermostat cover bolts to specification.
TORQUE
Thermostat Cover Bolts:
7 ft-lbs (10 Nm)
11. Be sure to properly fill and bleed cooling system as
outlined in this chapter.
9850045 R01 - 2020-2021 RANGER 1000 Service Manual
© Copyright Polaris Inc.
ENGINE / COOLING / EXHAUST

WATER PUMP SERVICE

WARNING
Ensure the engine has cooled down and no pressure is
present in the cooling system. Escaping coolant can
cause severe injury or burns.
REMOVAL
1. Disconnect the battery. Refer to Battery Service page
2.62.
2. Drain the engine coolant. Refer to Coolant Service
page 3.80.
3. Remove the right rear wheel. Refer to Wheel Service
page 2.52.
4. Remove the coolant hoses attached to the water
pump.
5. Remove the three fasteners securing the water pump
to the engine, and remove the water pump and water
pump seal.
NOTICE
If the water pump does not readily remove, use a
twisting and rocking motion to remove from the engine.
3
3.87

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ranger 1000 2021

Table of Contents