Polaris RANGER 1000 2020 Service Manual page 99

ITEM
XU / D Brake Pads / Parking Brake Pads (INT'L) Inspect pad wear; replace if worn beyond service limit
EVAP System
E
Fuel System
XU / D Parking Brake Cable Adjustment (INT'L)
XU / E Engine Breather
Battery
XU General Lubrication
D / E Throttle Pedal
Throttle Body Intake Ducts/Flange
E
Shift Cable / Linkage
Steering
D
Front / Rear Suspension
XU
Cooling System
D
D Drive Belt
Engine Oil Lines/Fasteners
XU
XU / E Engine Oil & Filter Change
XU Front Gearcase Lubricant
Transmission Lubricant (AGL)
XU
EVAP System
E
Fuel System
Spark Plug Inspection
D / E
XU Radiator
Cooling Hoses
XU
Engine Mounts
XU
Exhaust Silencer / Pipe
Wiring
XU
Front Wheel Bearings
D
XU Shocks
Cam Chain Tensioner
XU - Perform these procedures more often for vehicles subjected to severe use.
D - Have an authorized Polaris dealer perform these services.
E - Emission Control System Service (California)
9850045 R01 - 2020-2021 RANGER 1000 Service Manual
© Copyright Polaris Inc.
100 HOUR / 1000 MILE (1600 KM) SERVICE
REMARKS
Inspect Fuel and EVAP system if equipped.
Turn key on to pressurize fuel pump; check lines / fittings for leaks and
abrasion. Replace as needed.
Inspect; adjust tension after first 25 hours
Inspect; clean
Check terminals; clean; test
Lubricate all fittings, pivots, cables, etc.
Inspect; replace if it sticks
Inspect ducts for proper sealing / air leaks
Inspect; adjust as needed
Lubricate (if applicable)
Lubricate (if applicable)
Inspect coolant strength seasonally; pressure test system yearly
Inspect; replace as needed
Inspect for leaks and loose fittings
Change oil and filter, inspect used oil for contaminants
Change lubricant
Change lubricant
Inspect Fuel and EVAP system if equipped.
Turn key on to pressurize fuel pump; check lines / fittings for leaks and
abrasion. Replace as needed.
Inspect; replace as needed; torque to specification
Inspect; clean external surfaces
Inspect for leaks; pressure test system
Inspect, torque to specification
Inspect
Inspect for wear, routing, security; inspect connectors subjected to water,
mud, etc.
Inspect; replace as needed
Visually inspect shock seals; change oil and seals if leaking
Inspect/clean; replace as needed
MAINTENANCE
2
2.11