Shift Cable; Shift Lever Removal / Installation; Shift Cable Inspection - Polaris RANGER 1000 2020 Service Manual

SHIFT CABLE

SHIFT LEVER REMOVAL /
INSTALLATION
1. Remove the shift knob cover
w e
screw and shift knob
2. Remove the four push rivets retaining the upper dash
panel and remove the panel to access the shift lever.
3. Remove the rubber grommet
r
shift lever .
s
4. Remove nut retaining the shift cable
r
lever . Disconnect cable end from the lever.
5. Remove the retaining ring
r
off the mounting bracket and out from the frame.
a
6. Remove both bushings
service as needed.
7. Perform the previous steps in reverse order to
reinstall the shift lever (lever, cable, dash panel, shift
knob).
9850045 R01 - 2020-2021 RANGER 1000 Service Manual
© Copyright Polaris Inc.
q
. Remove retaining
r
from the shift lever .
t
from the dash and
i
to the shift
o
and slide the shift lever
from the shift lever and

SHIFT CABLE INSPECTION

1. Place the vehicle on a flat surface in park, chock the
wheels, and turn the ignition key off.
2. Remove rubber bezel surrounding the shifter.
3. Push shifter into High Gear while looking for dash
movement. If the plastic dash lifts and the shifter
contacts the cut-out before a shift is complete, the
shift cable is not adjusted correctly.
TRANSMISSION
7
7.3