Polaris RANGER 1000 2020 Service Manual page 115

ITEM
XU / D Brake Pads / Parking Brake Pads (INT'L) Inspect pad wear; replace if worn beyond service limit
EVAP System
E
Fuel System
XU / D Parking Brake Cable Adjustment (INT'L)
XU / E Engine Breather
Battery
XU General Lubrication
D / E Throttle Pedal
Throttle Body Intake Ducts/Flange
E
Shift Cable / Linkage
Steering
D
Front / Rear Suspension
XU
Cooling System
D
D Drive Belt
Engine Oil Lines/Fasteners
XU
XU / E Engine Oil & Filter Change
XU Front Gearcase Lubricant
Transmission Lubricant (AGL)
XU
Spark Plug Inspection
D / E
XU Radiator
Cooling Hoses
XU
Engine Mounts
XU
Exhaust Silencer / Pipe
Wiring
XU
Front Wheel Bearings
D
XU / D Shocks
D Brake Fluid
D / E Valve Clearance
Spark Plug Replacement
D / E
XU Coolant
Toe Adjustment
D
Cam Chain Tensioner
XU - Perform these procedures more often for vehicles subjected to severe use.
D - Have an authorized Polaris dealer perform these services.
E - Emission Control System Service (California)
When the vehicle goes beyond 500 hours / 5000 miles, return to the 25 hours / 250 mile chart and start the interval
process over.
9850045 R01 - 2020-2021 RANGER 1000 Service Manual
© Copyright Polaris Inc.
500 HOUR / 5000 MILE (8000 KM) SERVICE
REMARKS
Inspect Fuel and EVAP system if equipped.
Turn key on to pressurize fuel pump; check lines / fittings for leaks and
abrasion. Replace as needed.
Inspect; adjust tension after first 25 hours
Inspect; clean
Check terminals; clean; test
Lubricate all fittings, pivots, cables, etc.
Inspect; replace if it sticks
Inspect ducts for proper sealing / air leaks
Inspect; adjust as needed
Lubricate (if applicable)
Lubricate (if applicable)
Inspect coolant strength seasonally; pressure test system yearly
Inspect; replace as needed
Inspect for leaks and loose fittings
Change oil and filter, inspect used oil for contaminants
Change lubricant
Change lubricant
Inspect; replace as needed; torque to specification
Inspect; clean external surfaces
Inspect for leaks; pressure test system
Inspect, torque to specification
Inspect
Inspect for wear, routing, security; inspect connectors subjected to water,
mud, etc.
Inspect; replace as needed
Change shock oil and inspect seals
Change every two years (DOT 4)
Inspect; adjust as needed
Replace; torque to specification
Replace coolant
Inspect periodically; adjust when parts are replaced
Inspect/clean; replace as needed
MAINTENANCE
2
2.27