Exhaust Spark Arrestor Inspection - Polaris RANGER 1000 2020 Service Manual

EXHAUST SPARK ARRESTOR
INSPECTION
WARNING
Do not clean spark arrestor immediately after the
engine has been run, as the exhaust system becomes
very hot. Serious burns could result from contact with
the exhaust components. Allow components to cool
sufficiently before proceeding. Wear eye protection and
gloves.
Never run the engine in an enclosed area. Exhaust
contains poisonous carbon monoxide gas that can
cause loss of consciousnessor death in a very short
time.
Periodically clean spark arrestor to remove accumulated
carbon.
1. Remove the retaining screw
2. Remove the spark arrestor
e
silencer .
3. Use a non-synthetic brush to clean the arrestor
screen. A synthetic brush may melt if components are
warm. If necessary, blow debris from screen with
compressed air.
4. Inspect the screen for wear and damage. Replace if
needed.
5. Reinstall the arrestor and torque the retaining screw
to specification.
TORQUE
Spark Arrestor:
10 ft-lbs (14 Nm)
9850045 R01 - 2020-2021 RANGER 1000 Service Manual
© Copyright Polaris Inc.
q
.
w
from the end of the
MAINTENANCE
2
2.41