Polaris RANGER 1000 2020 Service Manual page 428

FINAL DRIVE
4. Place the drive shaft in a soft-jawed vise. Using a
soft-faced hammer, or brass drift, strike the inner race
of the joint to drive the joint off the drive shaft. Be sure
to tap evenly around the joint to avoid binding.
IMPORTANT
Tap on inner race only!
w
5. Make sure circlip is on the shaft and not left in the
joint.
6. Remove the CV boot from the shaft.
IMPORTANT
Complete disassembly of the CV joint is NOT
recommended. The internal components are precision
fit and develop their own characteristic wear patterns.
Intermixing the internal components could result in
looseness, binding, and/or premature failure of the joint.
IMPORTANT
If the grease in the joint is obviously contaminated with
water and/or dirt, the joint should be replaced.
8.54
7. Thoroughly clean the joint with an appropriate solvent
and dry the joint to prevent any residual solvent from
being left in the joint upon reassembly.
8. Visually inspect the joint by tilting the inner race to
one side to expose each ball. Severe pitting, galling,
play between the ball and its cage window, any
cracking or damage to the cage, pitting or galling or
chips in raceways call for joint replacement.
NOTICE
Shiny areas in ball tracks and on the cage spheres are
normal. Do not replace CV joints because parts have
polished surfaces. Replace CV joint only if components
are cracked, broken, worn or otherwise unserviceable.
9. Clean the splines on the end of the shaft and apply a
light coat of grease prior to reassembly.
10. Slide the small boot clamp and boot (small end first)
onto the drive shaft and position the boot in it's
groove machined in the shaft.
11. Install a new circlip on the end of the shaft.
12. Grease the joint with the special CV joint grease
provided in the boot replacement kit. Fill the cavity
behind the balls and the splined hole in the joint's
inner race. Pack the ball tracks and outer face flush
with grease. Place any remaining grease into the
boot.
IMPORTANT
The grease provided in the replacement kit is specially
formulated for wear resistance and durability. DO NOT
use substitutes or mix with other lubricants.
IMPORTANT
The amount of grease provided in the boot kit is pre-
measured. Use entire contents of package.
9850045 R01 - 2020-2021 RANGER 1000 Service Manual
© Copyright Polaris Inc.