Polaris RANGER 1000 2020 Service Manual page 396

FINAL DRIVE
5. Remove the torsion spring retainer
y
spring from the top of the ring gear.
6. Remove the clutch housing / ring gear and roll cage
u
assembly from the gearcase housing. With the ring
gear removed inspect the ring gear roll pin and
ensure that it is seated correctly.
8.22
t
and torsion 7. Remove the RH output hub assembly
8. Remove pinion seal
9. Inspect the pinion gear
gearcase housing.
o
, internal retaining ring
s
pinion gear assembly from the gearcase housing.
Inspect and clean the gearcase housing and replace
all oil seals and O-rings.
s
missing teeth. Inspect the pinion bearing for signs of
wear and the pinion shaft seal surface for pitting.
9850045 R01 - 2020-2021 RANGER 1000 Service Manual
i
from the
a
, and
for chipped, broken or
© Copyright Polaris Inc.