Polaris RANGER 1000 2020 Service Manual page 207

8. Remove the eleven M6 upper crankcase fasteners
from the top of the motor.
t
9. Remove the M6 fastener
motor.
10. Remove the eight M10 fasteners
u
fasteners from the bottom of the motor.
11. Gently pry the lower crankcase apart from the engine
and remove.
INSTALLATION
1. Clean the gasket surface of the engine.
9850045 R01 - 2020-2021 RANGER 1000 Service Manual
© Copyright Polaris Inc.
r
from the bottom of the
y
and two M8
ENGINE / COOLING / EXHAUST
2. Clean the gasket surface on the upper crankcase and
apply a thin film of crankcase sealant (PN 2881416.
3. Install the upper crankcase on the engine and align
with the mounting holes.
4. Install eight NEW M10 fasteners
u
fasteners from the bottom of the motor and torque
to specification..
TORQUE
Upper Crankcase Fasteners (M8):
26 ft-lbs (35 Nm)
Upper Crankcase Fasteners (M10):
Step 1: 9 ft-lb (12 Nm)
Step 2: 21 ft-lb (28 Nm)
Step 3: Tighten additional 90°
t
5. Install the M6 fastener from the bottom of the
motor and torque to specification.
TORQUE
Upper Crankcase Fasteners (M6):
7 ft-lbs (10 Nm)
3
y
and two M8
3.55