Front Gearcase Fluid Level Inspection - Polaris RANGER 1000 2020 Service Manual

6. With the cable removed from the bracket, turn the
y
upper jam nut to adjust the cable. Moving the
y
upper jam nut closer to the shift cable boot creates
a larger gap in high. Moving the upper jam nut
away from the shift cable boot creates a larger gap in
park.
NOTICE
1 full turn of the adjustment nut
1 mm of dash gap.
CLOSER TO DASH IN HIGH GEAR
CLOSER TO DASH IN PARK
7. Reinstall the cable in the bracket.
9850045 R01 - 2020-2021 RANGER 1000 Service Manual
© Copyright Polaris Inc.
8. While holding the upper jam nut
y
y
equals approximately
9. After adjustment verify there is no contact with the
10. Reinstall the rubber bezel.
11. With the engine off, check the following:
FRONT GEARCASE FLUID LEVEL
INSPECTION
The front gearcase fluid level should be checked and
changed in accordance with the maintenance schedule.
to tighten the lower jam nut
specification.
IMPORTANT
When setting torque using a crows foot, the socket
must be at a 90° angle to the torque wrench as shown.
TORQUE
Lower Jam Nut:
13 ft-lbs (18 N·m)
dash in both Park/High. If the shifter is still contacting
the dash, repeat the adjustment procedure until there
is no contact with the dash.
• Shifter fully engages all gears.
• Dash is not moving when shifting into Park/High
NOTICE
It is important to follow the front gearcase maintenance
intervals described in the Periodic Maintenance Chart.
MAINTENANCE
y
use a crows foot
t
. Torque to
2.49
2