Engine Maintenance; Engine Oil Level Inspection - Polaris RANGER 1000 2020 Service Manual

ENGINE MAINTENANCE

ENGINE OIL LEVEL INSPECTION

This engine has a wet-sump design, meaning the engine
oil is contained in the bottom of the crankcase. To check
the oil level, follow the procedure listed below:
FLUID CAPACITY
Recommended Engine Oil:
Capacity: 2.5 Qt (2.4 L)
PS-4 5W-50 Full Synthetic
Ambient Temp Range: -35° F to 100° F
PS-4 10W-50 Extreme Duty Full Synthetic
Ambient Temp Range: 0° F to 120° F
1. Position vehicle on a level surface and place the
transmission in PARK.
2. Stop the engine and allow it to cool down before
removing the dipstick.
3. Raise the cargo box. Unlock the dipstick lever
Remove the dipstick and wipe it dry with a clean
cloth.
4. Reinstall the dipstick and push it into place. Do not
lock the dipstick.
NOTICE
Make certain the dipstick is inserted all the way into the
dipstick tube to keep the depth of the dipstick
consistent.
9850045 R01 - 2020-2021 RANGER 1000 Service Manual
© Copyright Polaris Inc.
5. Remove the dipstick and check the oil level.
The oil level should be within the SAFE range on
dipstick. Do not overfill (see NOTE below).
q
.
A rising oil level between checks during cold weather
operation can indicate contaminants such as gas or
moisture collecting in the crankcase. If the oil level is
over the upper mark, change the oil immediately.
6. If needed, add engine oil through the oil fill cap
located on top of the valve cover, under the cargo
box.
7. Recheck the oil level and ensure if is within the SAFE
range on the dipstick.
8. When finished, reinstall dipstick and lock the lever.
Lower the cargo box and secure in position.
MAINTENANCE
IMPORTANT
NOTICE
w
2
2.31