Rear Hub Identification - Polaris RANGER 1000 2020 Service Manual

FINAL DRIVE

REAR HUB IDENTIFICATION

The two hubs can be identified with the table below. Each hub will use a different quantity of washers to be used during
installation. The torque specifications are also different between the two hubs. After the hub is identified, refer to the
applicable Service Manual instructions for the correct removal and installation procedures.
Both hubs use Belleville style washers. All Belleville washers must be installed with the dome side facing out.
ALUMINUM HUB (PN 5137431)
q
• Casting indentations
studs.
• Non-Magnetic – Inspect using a small magnet.
• Uses TWO Belleville washers
Rear Wheel Hub Castle Nut:
Aluminum Hub – 110 ft-lbs (149 N·m)
8.4
will be offset from the wheel
w
(PN 7555796).
TORQUE
IMPORTANT
IRON HUB (PN 5142964)
• Casting indentations
studs.
• Magnetic – Inspect using a small magnet.
• Uses ONE Belleville washer
Rear Wheel Hub Castle Nut:
Iron Hub – 180 ft-lbs (244 N·m)
9850045 R01 - 2020-2021 RANGER 1000 Service Manual
e
will be inline with the wheel
r
(PN 7557134).
TORQUE
© Copyright Polaris Inc.