Heater Valve Service - Polaris RANGER 1000 2020 Service Manual

ENGINE / COOLING / EXHAUST
8. Install the three water pump hoses and torque the
hose clamps to specification.
TORQUE
Coolant Hose Clamp:
35 in-lbs (4 Nm)
9. Fill and bleed the Cooling system. Refer to Coolant
Service page 3.80.
10. Install the right rear wheel. Refer to Wheel Service
page 2.52.
11. Connect the battery. Refer to Battery Service page
2.62.
3.92

HEATER VALVE SERVICE

1. Drain the cooling system. Refer to Coolant Service
page 3.80.
2. Remove the three coolant hoses attached to the
heater valve.
3. Remove the four heater valve fasteners to remove
the heater valve.
TORQUE
Heater Valve Fasteners:
6 ft-lbs (8 Nm)
4. Fill and bleed the cooling system. Verify no leaks are
present. Refer to Coolant Service page 3.80.
9850045 R01 - 2020-2021 RANGER 1000 Service Manual
© Copyright Polaris Inc.