9.9.2 Client-Switch Management
By right-clicking on the neighbor non-Lite management switch (L2 switch), the following
menu will appear and you can configure, as shown below.
Non-Lite management switch and other devices menu:
Save All Device Location
To fix the location of all devices on the map, so that it restores its places after refresh.
Login Homepage
To login to the client device Homepage, and make necessary changes after entering
suitable username and password.
10. MISC
10.1
Cable Test
This feature determines the quality of the cables, shorts, and cable impedance mismatch, bad
connectors, termination mismatch, and bad magnetics. The feature can work on the copper
Ethernet cable only. The cable testers can measure the signal strength and attenuation of the cable
during transmission.
Note: Cable tester can only accesable through the CLI without any GUI support.
10.1.1 CLI Configurations
Node
Command
Enable
configure terminal
configure interface IFNAME
Description
This command changes the node to
configure node.
This command enters the interface
344