Mounting The Switch - Tripp Lite NFI-U08-2A Owner's Manual

DIN-Rail Mounting and Dismounting Instructions
ATTENTION: The NFI-U08-2A is an open-type device
and shall be DIN-rail mounted or wall mounted
(optional) in a cabinet or rack enclosure. The
ambient temperature should not exceed 75°C
(167°F).

Mounting the Switch

Place the switch on the DIN rail from above using the built-in
slot. Push the front of the switch toward the mounting surface
until it snaps into place. You will hear a "click" to indicate it has
successfully snapped into place.
Dismounting the Switch
Press the switch from the top, then pull out the lower edge of the
switch to remove it from the DIN rail.
Mounting the Switch
Push
Click
Removing the Switch
5
Push
Click