Snmp Trap; Trap Receiver; Cli Configurations; Web Configurations - Tripp Lite NGI-M08POE8-L2 Owner's Manual

9.1.2 SNMP Trap

9.1.2.1 Trap Receiver

9.1.2.1.1 CLI Configurations

Node Command
enable show snmp
enable configure terminal
configure snmp trap-receiver
IPADDR (v1|v2c)
COMMUNITY
configure snmp trap-ipv6-
receiver IPADDR
(v1|v2c)
COMMUNITY

9.1.2.1.2 Web Configurations

Parameter
IP Address
Version
Community String
Apply
Refresh
Trap Receiver List
Action
This command displays the SNMP configurations.
This command changes the node to configure node.
This command configures the trap receiver's
configurations, including the IP address, version (v1 or
v2c) and community.
This command configures the trap IPv6 receiver's
configurations, including the IP address, version (v1 or
v2c) and community.
Description
Enter the IP address of the remote trap station in dotted decimal
notation.
Select the version of the Simple Network Management Protocol to use.
v1 or v2c.
Specify the community string used with this remote trap station.
Click Apply to take effect the settings.
Click Refresh to begin configuring this screen afresh.
Click Delete to remove a configured trap receiver station.
302
Description