Cli Configuration - Tripp Lite NGI-M08POE8-L2 Owner's Manual

IP multicast
Description
address
224.0.0.0 Base address (reserved)
The All Hosts multicast group that contains all systems on the same network
224.0.0.1
segment
The All Routers multicast group that contains all routers on the same network
224.0.0.2
segment
The Open Shortest Path First (OSPF) All SPF Routers address. Used to send
224.0.0.5
Hello packets to all OSPF routers on a network segment
The OSPF All D Routers address. Used to send OSPF routing information to
224.0.0.6
OSPF designated routers on a network segment
The RIP version 2 group address, used to send routing information using the
224.0.0.9
RIP protocol to all RIP v2-aware routers on a network segment
EIGRP group address. Used to send EIGRP routing information to all EIGRP
224.0.0.10
routers on a network segment
224.0.0.13 PIM Version 2 (Protocol Independent Multicast)
224.0.0.18 Virtual Router Redundancy Protocol
224.0.0.19 - 21 IS-IS over IP
224.0.0.22 IGMP Version 3 (Internet Group Management Protocol)
224.0.0.102 Hot Standby Router Protocol Version 2
224.0.0.251 Multicast DNS address
224.0.0.252 Link-local Multicast Name Resolution address
224.0.1.1 Network Time Protocol address
224.0.1.39 Cisco Auto-RP-Announce address
224.0.1.40 Cisco Auto-RP-Discovery address
224.0.1.41 H.323 Gatekeeper discovery address

6.2.5.1 CLI Configuration

Node
enable show mac-address-table
multicast
enable show mac-address-table
multicast vlan <1-4094>
enable configure terminal
configure mac-address-table multicast
MACADDR vlan <1-4094>
ports PORTLIST
Command
105
Description
This command displays the current
static/dynamic multicast address entries.
This command displays the current
static/dynamic multicast address entries with
a specific VLAN.
This command changes the node to configure
node.
This command configures a static multicast
entry.