Cli Configurations - Tripp Lite NGI-M08POE8-L2 Owner's Manual

Notices:
TACACS+ service must be enabled before configuring the authentication, authorization and

accounting parameters, otherwise it will return error as TACACS+ service is not enabled.
Not allowed to disable the Authentication login mode when both enabled login-mode and

login local.
Not allowed to disable the Authentication enable mode when both enabled enable-mode and

enable local.
Not allowed to enable the login-mode local when login-mode is in disable.

Not allowed to enable the enable-mode local when enable-mode is in disable.

For input CLI, user must supply full command or partial command with TAB (command

must be completed). The reason is only the command after user HIT the ENTER is only
send to TACACS+ server for authorization or accounting. So if this command is partial then
subsequently authorization or accounting fails.

7.5.1 CLI Configurations

Mode
enable show tacacs-plus
enable configure terminal
configure tacacs-plus server-host <ipaddr>
configure no tacacs-plus server-host
configure tacacs-plus server-key <key>
configure no tacacs-plus server-key
Command
284
Description
To show the TACACS+ Statistics.
This command changes the node to configure
node.
To set the TACACS+ Server ip address.
To reset the TACACS+ Server ip address as
0.0.0.0.
To set the TACACS+ server key.
To reset the TACACS+ server key as default
key( NULL means no key).