General Settings; Cli Configurations - Tripp Lite NGI-M08POE8-L2 Owner's Manual

6.14.1 General Settings

6.14.1.1 CLI Configurations

Node Command
enable show spanning-tree active
enable show spanning-tree blocked
ports
enable show spanning-tree summary
enable clear spanning-tree counters
enable clear spanning-tree counters
PORT_ID
enable configure terminal
configure spanning-tree (disable |
enable)
configure spanning-tree algorithm-timer
forward-time TIME max-age
TIME hello-time TIME
configure no spanning-tree algorithm-
timer
configure spanning-tree forward-time
<4-30>
configure no spanning-tree forward-time
configure spanning-tree hello-time <1-
10>
configure no spanning-tree hello-time
configure spanning-tree max-age <6-40> This command configures the bridge message
configure no spanning-tree max-age
configure spanning-tree mode
(rstp|stp|mst)
configure spanning-tree path-cost
method (short|long)
configure spanning-tree priority <0-
61440>
configure no spanning-tree priority
Description
This command displays the spanning tree
information for only active port(s).
This command displays the spanning tree
information for only blocked port(s).
This command displays the summary of port
states and configurations.
This command clears spanning-tree statistics
for all ports.
This command clears spanning-tree statistics
for a specific port.
This command changes the node to configure
node.
This command disables / enables the spanning
tree function for the system.
This command configures the bridge
times(forward-delay, max-age, hello-time).
This command configures the default values for
forward-time &max-age &hello-time.
This command configures the bridge forward
delay time (sec).
This command configures the default values for
forward-time.
This command configures the bridge hello time
(sec).
This command configures the default values for
hello-time.
max-age time (sec).
This command configures the default values for
max-age time.
This command configures the spanning mode.
This command configures the path-cost
method.
This command configures the priority for the
system.
This command configures the default values for
the system priority.
218