Port Parameters; Cli Configurations - Tripp Lite NGI-M08POE8-L2 Owner's Manual

Refresh

6.14.4.3 Port Parameters

6.14.4.3.1 CLI Configurations

Node Command
enable show spanning-tree mst
interface IFNAME
enable configure terminal
configure interface IFNAME
interface spanning-tree mst instance
STRING cost <1-200000000>
interface no spanning-tree mst instance
STRING cost
interface spanning-tree mst instance
STRING port-priority <0-240>
interface no spanning-tree mst instance
STRING port-priority
interface spanning-tree (disable|enable)
interface spanning-tree bpdufilter
(disable|enable)
interface spanning-tree bpduguard
(disable|enable)
interface spanning-tree rootguard
(disable|enable)
interface spanning-tree edge-port
(disable|enable)
interface spanning-tree cost VALUE
interface no spanning-tree cost
interface spanning-tree port-priority <0-
240>
interface no spanning-tree port-priority
configure interface range
gigabitethernet1/0/PORTLISTS
if-range spanning-tree (disable|enable)
Click Refresh to begin configuring this screen afresh.
This command displays the configurations on
an interface of the MSTP.
This command changes the node to configure
node.
This command enters the interface configure
node.
This command configures a cost on the
specific port for the MSTP.
This command resets the cost on the specific
port for the MSTP.
This command configures a priority on the
specific port for the MSTP.
This command resets the priority on the
specific port for the MSTP.
This command configures enables/disables the
STP function for the specific port.
This command configures enables/disables the
bpdu filter function for the specific port.
This command configures enables/disables the
bpdu guard function for the specific port.
This command enables/disables the BPDU
Root guard port setting for the specific port.
This command enables/disables the edge port
setting for the specific port.
This command configures the cost for the
specific port.
Cost range:
16-bit based value range 1-65535,
32-bit based value range 1-200000000.
This command configures the path cost to
default for the specific port.
This command configures the port priority for
the specific port.
Default: 128.
This command configures the port priority to
default for the specific port.
This command enters the if-range configure
node.
This command configures enables/disables the
STP function for the specific port.
232
Description