System Status; Console Port; Telnet; How To Enter The Cli - Tripp Lite NGI-M08POE8-L2 Owner's Manual

4. System Status

4.1. Console Port

Connect your computer to the console port on the Switch using the appropriate cable.

Use terminal emulation software with the following settings:

Terminal Emulation
Baud Rate
Parity
Number of Data Bits
Number of Stop Bits
Flow Control
Press [ENTER] to open the login screen.

Default Username
Default Password

4.2. Telnet

Connect your computer to one of the Ethernet ports.

Open a Telnet session to the Switch's IP address. If this is your first login, use the

default values.
IP Address
Subnet Mask
Default Gateway
Management VLAN
Default Username
Default Password
Make sure your computer IP address is in the same subnet, unless you are accessing

the Switch through one or more routers.

4.3. How to enter the CLI?

Press [Enter] key to enter the login command prompt when below message is displayed on the
screen.
Press Enter to activate this console
Input "admin" to enter the CLI mode when below message is displayed on the screen.
L2SWITCH login:
You can execute a few limited commands when CLI prompt is displayed as below.
L2SWITCH>
If you want to execute more powerful commands, you must enter the privileged mode.
Default Settings for the Console Port
Setting
VT100
38400
None
8
1
None
Setting
admin
admin
Default Management IP Address
Setting
192.168.0.254
255.255.255.0
0.0.0.0
1
admin
admin
27
Default Value
Default Value
Default Value