Led Indicators - Tripp Lite NGI-M08POE8-L2 Owner's Manual

is lit. If not, check that the power cable is correctly and securely plugged in.
Notice: Turn off the power before connecting modules or wires.
- The correct power supply voltage is listed on the product label. Check the voltage of
your power source to make sure that you are using the correct voltage. Do NOT use a
voltage greater than what is specified on the product label.
- Calculate the maximum possible current in each power wire and common wire.
Observe all electrical codes dictating the maximum current allowable for each wire
size. If current go above the maximum ratings, the wiring could overheat, causing
serious damage to your equipment.
Reset Button
There has "Reset" button in front of Switch which can help to manually hardware reboot.

3.3. LED Indicators

This Switch is equipped with Unit LEDs to enable you to determine the status of the Switch, as
well as Port LEDs to display what is happening in all your connections. They are as follows:
LED
PWR
RPS
ALM
Unit LEDs
Condition Status
Illuminated Primary power is supplied to switch.
Off Primary power off or failure.
Illuminated Redundant power is supplied to switch.
Off Redundant power off or failure.
External signal device will be activated through
Illuminated
terminal block ALM when there is any alarm.
24