Trap Event; Cli Configurations - Tripp Lite NGI-M08POE8-L2 Owner's Manual

9.1.2.2 Trap Event

The features allow users to enable/disables individual trap notification.
alarm-over-heat
alarm-over-load
alarm-power-fail
bpdu
dual-homing
dying-gasy
loop-detection
pd-alive
port-admin-state-change - Trap when port is enabled/disable by administrator.
port-link-change
power-source-change
stp-topology-change
traffic-monitor
xpress-ring

9.1.2.2.1 CLI Configurations

Node
enable show snmp trap-event
enable configure terminal
configure snmp trap-event alarm-over-heat
(disable/enable)
configure snmp trap-event alarm-over-load
(disable/enable)
configure snmp trap-event alarm-power-fail
(enable/enable)
configure snmp trap-event bpdu
(disable/enable)
configure snmp trap-event dual-homing
(disable/enable)
configure snmp trap-event dying-gasp
(disable/enable)
configure snmp trap-event loop-detection
(disable/enable)
configure snmp trap-event pd-alive
(disable/enable)
configure snmp trap-event port-admin-state-
- Trap when system's temperature is too high.
- Trap when system is over load.
- Trap when system power is over voltage/under voltage/
RPS over voltage/RPS under voltage.
- Trap when port is blocked by BPDU Guard/BDPU Root
Guard/BPDU port state changed.
- Trap when port is blocked by Dual Homing.
- Trap when system is power off.
- Trap when port is blocked by Loop Detection.
- Trap when PD device has no responses.
- Trap when port is link up/down change.
- Trap when the power source has been changed.
(AC to DC or DC to AC)
- Trap when the STP topology change.
- Trap when port is blocked by Traffic Monitor.
- Trap when port is blocked by Xpress Ring.
Command
303
Description
This command displays the SNMP
configurations.
This command changes the node to
configure node.
This command enables/disables the
alarm-over-heat trap.
This command enables/disables the
alarm-over-load trap.
This command enables/disables the
alarm-power-fail trap.
This command enables/disables the
BPDU port state change/BPDU Root
Guard/BPDU Guard trap.
This command enables/disables the
dual-homing trap.
This command enables/disables the
dying-gasp trap.
This command enables/disables the
loop-detection trap.
This command enables/disables the pd-
alive trap.
This command enables/disables the