Port Settings; Cli Configuration - Tripp Lite NGI-M08POE8-L2 Owner's Manual

6.11.7 Port Settings

6.11.7.1 CLI Configuration

Node
Enable show ptp port <Domain-
ID> <Port-ID>
enable configure terminal
configure ptp primary-domain
<Domain-ID>
configure no ptp primary-domain
configure ptp domain <Domain-
ID>
configure no ptp domain <Domain-
ID>
ptp_config port <Port-ID>
ptp_config no port <Port-ID>
ptp_config_port port enable
ptp_config_port no port enable
ptp_config_port acceptable-master enable
ptp_config_port no acceptable-master
enable
ptp_config_port announce interval <0-4>
ptp_config_port no announce interval
ptp_config_port announce timeout <2-
10>
ptp_config_port no announce timeout
ptp_config_port sync interval [-1, 1]
ptp_config_port no sync interval
ptp_config_port vlan <VLAN LIST>
ptp_config_port no vlan <VLAN LIST>
ptp_config_port exit
Command
This command displays specified PTP domain
and port configurations.
This command changes the node to configure
node.
This command configures a specified Domain
ID as the PTP's primary domain.
This command resets the primary domain ID
default domain ID (0).
This command creates a specified domain in
PTP.
This command deletes a specified domain ID
from PTP.
This command creates port data sets in PTP
domain.
This command deletes port data sets from
PTP domain.
This command enables PTP port in domain.
This command disables PTP port in domain.
This command enables PTP port in domain as
acceptable master.
This command deletes PTP port in domain
from acceptable master list.
This command configures to send periodical
announce messages in specified intervals in
PTP port.
This command deletes existing announce
interval from PTP port and adds default
interval (1).
This command configures specified value as
announce time in PTP port.
This command deletes existing announce
timeout from PTP port and adds default
timeout (3).
This command configures synchronization
interval of PTP port as specified value.
This command deletes existing
synchronization interval from PTP port and
adds default value (0).
This command configures specified VLAN
list to PTP port.
This command deletes specified VLAN list
from PTP port.
This command provides command prompt
195
Description