Mvr Settings; Cli Configuration - Tripp Lite NGI-M08POE8-L2 Owner's Manual

Notices
• IGMP snooping and MVR can be independently enabled.
• IGMP snooping and MVR use the same IGMP timers.
• MVR can recognize IGMPv3 reports.
• About the IGMPv3 report, switch does not treat those group records with the following
group record types as membership reports. Those group record types are
MODE_IS_INCLUDE,
ALLOW_NEW_SOURCES and BLOCK_OLD_SOURCES.
• Do not use the group address X.0.0.1 for your multicast stream. It is because the system
detects and records the 224.0.0.1 for dynamic querier port. The group address X.0.0.1
may conflict with 224.0.0.1.
• Because the lower 23 bits of the 28-bit multicast IP address are mapped into the 23 bits
of available Ethernet address space. When you configure group address, the Switch
compares the lower 23 bits only.
• CLI command "group 1 start-address 224.1.1.1 6", it creates 6 groups. That is, one IP,
one group.
• The MVR name should be the combination of the digit or the alphabet.
• The group name should be the combination of the digit or the alphabet.

6.2.4.1 MVR Settings

6.2.4.1.1 CLI Configuration

Node Command
enable show mvr
enable show mvr vlan
VLANLISTS
enable configure terminal
configure mvr VLANLISTS
configure no mvr VLANLISTS
MVR inactive
MVR no inactive
MVR mode
(dynamic|compatible)
MVR name STRING
MVR no name
MVR receiver-port
PORTLIST
MVR no receiver-port
PORTLIST
CHANGE_TO_INCLUDE_MODE,
Description
This command displays the current MVR
configurations.
This command displays the current MVR configurations
of the specific VLAN.
This command changes the node to configure node.
This command configures the MVR configurations for
the specific VLAN.
This command disables the MVR configurations for the
specific VLAN.
This command disables the MVR settings.
This command enables the MVR settings.
This command configures the mode for the MVR.
Dynamic : Sends IGMP report to all MVR source

ports in the multicast VLAN.
Compatible : Sets the Switch not to send IGMP

report.
This command configures the name for the MVR.
This command configures the default name for the
MVR.
This command sets the receiver port(s). Normally the
source ports are connected to the streaming client.
This command removes a port or range of ports from
the receiver port(s).
99