Onvif; Cli Configurations; Web Configurations - Tripp Lite NGI-M08POE8-L2 Owner's Manual

9.8.3 ONVIF

9.8.3.1 CLI Configurations

Node Command
enable show onvif
enable configure terminal
config onvif enable
config onvif tx-interval
<6-3600>
config no onvif enable
config no onvif tx-interval

9.8.3.2 Web Configurations

Parameter
ONVIF Settings
State
Tx Interval
Apply
Refresh
ONVIF Neighbor Information
Port
IP Address
This command displays the ONVIF configurations.
This command changes the node to configure node.
This command enables the ONVIF on the Switch.
This command configures the tx interval for the
ONVIF.
This command disables the ONVIF on the Switch.
This command reset the tx interval to default for the
ONVIF.(Default: 6 seconds).
Description
Select option to enable / disable the ONVIF feature on the
Switch.
Configures the sending ONVIF discovery packet interval.
Valid range is 6 ~ 3600 seconds.
Click Apply to take effect the settings.
Click Refresh to begin configuring this screen afresh.
The connected port of the ONVIF device.
The IP address of the ONVIF device.
339
Description