Static Route; Cli Configuration - Tripp Lite NGI-M08POE8-L2 Owner's Manual

6.13 Static Route

Static routes, which define explicit paths between two routers, cannot be automatically updated;
you must manually reconfigure static routes when network changes occur. Static routes use less
bandwidth than dynamic routes. No CPU cycles are used to calculate and analyze routing updates.
IP forwarding
IP forwarding provides on end to end delivery of IP packet between hosts with help of routers.
Routing database plays import role in forwarding the packets. Routers populate its routing
database either by manual configurations or by using dynamic routing protocols.
IP forwarding works as router as well as Inter VLAN routing with trunk stick.
Manual routing configurations are called as Static routes. Static routes are permanent routes; we
can delete those routes with manual configurations only.
Whenever an IP packet received by a router then it fetches destination IP address and it will do
the lookup in routing table to find the longest prefix match route. Packet is forwarded on the
assigned next-hop in the route.

6.13.1 CLI configuration

Node
enable show ip forwarding status
enable show ip routes(all|ipv4|ipv6)
enable show ip arp(all|ipv4|ipv6)
enable show ip hosts(all|ipv4|ipv6)
enable configure terminal
configure ip forwarding enable
configure no ip forwarding enable
configure ip arp proxy enable
configure no ip arp proxy enable
configure ipv4 arp
<IPv4_ADDR><MAC_ADDR>
configure ip6 arp
<IPv6_ADDR><MAC_ADDR>
configure no ipv4 arp
Command
209
Description
This command displays the current
configuration of the ip forwarding status.
This command displays the configurations of
IPv4 or IPv6 or both routes from routing
table.
This command displays dynamic and static
IPv4 orIPv6or both ARP entries in ARP table.
This command displays assigned IPv4 or IPv6
or both addresses for interfaces in router.
This command changes the node to configure
node.
This command enables layer 3 IPv4 and IPv6
forwarding/routing globally.
This command disables layer 3 IPv4 and IPv6
forwarding/routing globally.
This will delete all assigned IP addresses and
static routes from interfaces.
This command enables route to act as an ARP
proxy globally; It will be useful in Inter
VLAN routing.
This command disables route to act as an ARP
proxy.
This command allows adding static IPv4 ARP
entry in ARP table.
This command allows adding static IPv6 ARP
entry in ARP table.
This command deletes a static IPv4 ARP entry