Traffic Monitor; Cli Configurations - Tripp Lite NGI-M08POE8-L2 Owner's Manual

8.6 Traffic Monitor

The function can be enabled / disabled on a specific port or globally be enabled disabled on the
Switch. The function will monitor the broadcast / multicast / broadcast and multicast packets rate.
If the packet rate is over the user's specification, the port will be blocked. And if the recovery
function is enabled, the port will be enabled after recovery time.

8.6.1 CLI Configurations

Node Command
enable show traffic-monitor
enable configure terminal
configure traffic-monitor
(disable|enable)
configure interface IFNAME
interface traffic-monitor
(disable|enable)
interface traffic-monitor rate
RATE_LIMIT type
(bcast|mcast|bcast+mc
ast)
interface traffic-monitor
recovery
(disable|enable)
interface traffic-monitor
recovery time <1-60>
interface traffic-monitor
quarantine times
<1-20>
configure interface range
gigabitethernet1/0/
PORTLISTS
if-range traffic-monitor
(disable|enable)
if-range traffic-monitor
rateRATE_LIMIT
type
(bcast|mcast|bcast+mc
ast)
if-range traffic-monitor
recovery
(disable|enable)
if-range traffic-monitor
recovery time <1-60>
Description
This command displays the traffic monitor
configurations and current status.
This command changes the node to configure node.
This command enables / disables the traffic monitor on
the Switch.
This command enters the interface configure node.
This command enables / disables the traffic monitor on
the port.
This command configures the packet rate and packet
type for the traffic monitor on the port.
bcast – Broadcast packets.
mcast – Multicast packets.
bcast+ mcast - Broadcast packets and Multicast
packets.
This command enables / disables the recovery function
for the traffic monitor on the port.
This command configures the recovery time for the
traffic monitor on the port.
This command configures the quarantine times for the
traffic monitor on the port.
This command enters the if-range configure node.
This command enables / disables the traffic monitor on
the port.
This command configures the packet rate and packet
type for the traffic monitor on the port.
bcast – Broadcast packets.
mcast – Multicast packets.
bcast+ mcast - Broadcast packets and Multicast
packets.
This command enables / disables the recovery function
for the traffic monitor on the port.
This command configures the recovery time for the
traffic monitor on the port.
295