Ystem Og; Cli Configurations - Tripp Lite NGI-M08POE8-L2 Owner's Manual

9.5 System Log
The syslog function records some of system information for debugging purpose. Each log
message recorded with one of these levels, Alert / Critical / Error / Warning / Notice /
Information. The syslog function can be enabled or disabled. The default setting is disabled.
The log message is recorded in the Switch file system. If the syslog server's IP address has been
configured, the Switch will send a copy to the syslog server.
The log message file is limited in 4KB size. If the file is full, the oldest one will be replaced.

9.5.1 CLI Configurations

Node Command
enable show syslog
enable show syslog level
LEVEL
enable show syslog server
enable configure terminal
configure clear syslog
configure syslog-server
(disable|enable)
configure syslog-server ipv4-ip
IPADDR
configure syslog-server ipv6-ip
IPADDR
configure syslog-server facility
configure archive upload-
syslog <URL PATH>
configure archive ipv6-upload-
syslog <URL PATH>
Example:
L2SWITCH#configure terminal
L2SWITCH(config)#syslog-server ipv4-ip 192.168.200.106
L2SWITCH(config)#syslog-server enable
Description
The command displays the entire log message recorded
in the Switch.
The command displays the log message with the
LEVEL recorded in the Switch.
The command displays the syslog server configurations.
This command changes the node to configure node.
The command clears the syslog message.
The command disables / enables the syslog server
function.
The command configures the syslog server's IP address
in IPv4 format.
The command configures the syslog server's IP address
in IPv6 format.
The command configures the syslog facility level.
This command uploads the syslog file to a TFTP server.
This command uploads the syslog file to a IPv6 TFTP
server.
328