Starting The Instrument Console - Waters ACQUITY UPLC M-Class System Manual

Table 3–3: Run LED indications (continued)
LED mode and color
Steady red
Flashing red and green
3.1.5.3 TVM: Run LED
The Run LED, located on the right side of the power LED on the TVM's front panel, indicates the
run status.
Table 3–4: Run LED indications
LED mode and color
Unlit
Steady green
Flashing green
Flashing red
Steady red
Flashing red and green

3.2 Starting the instrument console

The instrument console is a software application that provides a way to configure settings,
monitor performance, run diagnostic tests, and maintain the system and its modules. It replaces
the keypads and small-screen displays traditionally found on the front of system modules. The
instrument console functions independently of data applications and does not recognize or control
them.
Description
Indicates a failure of a module that prevents its
further operation. Power-off the module, and
then restart it. If the LED is still steady red,
contact your Waters service representative.
Used as a visual identification of a module
after it is selected via the console.
Description
Module is idle.
The TVM is operating normally and attempting
to complete any outstanding samples. When
sample requests are finished, the LED reverts
to the unlit mode.
Initializing and preparing for normal operation.
Error state. Refer to the instrument console for
information about the error.
Indicates a failure of a module that prevents its
further operation. Power-off the module, and
then restart it. If the LED is still steady red,
contact your Waters service representative.
Used as a visual identification of a module
after it is selected via the console.
November 26, 2019, 715003588 Revision C
Page 51