Manifold For Maintop Burners - Removal And Replacement - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
6.9.7 Manifold for Maintop Burners – Removal and
Replacement
The manifold is sold as an assembly, which comes with all the
valves pre-installed. Valves can be installed independently, without
replacing the manifold assembly.
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
Figure 141: Typical Manifold for Maintop Burners
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 25.
2. Follow all steps in Accessing Components under the Maintop,
page 25.
3. Remove all knobs from their respective valve stems by slowly
pulling the knobs straight out, away from control panel.
4. Remove the backguard (see Backguard Removal and
Replacement, page 100).
5. Remove the control panel (see Control Panel Removal and
Replacement, page 35).
58300000163852_ARA_EN_C
6. Detach all wire connectors to the LED indicators, temperature
gauge, potentiometers, solenoid valves, and microswitches, and
make a note of how all the wires are connected.
NOTE: It is always recommended to label and tag all wires, wire
connectors and harnesses prior to disconnecting them, so as to
correctly identify their connections/locations when reassembling.
Alternatively, you can photograph the wire connections prior to
disconnecting (for example, with your mobile phone).
7. At each of the locations shown in Figure 37 on page 35, remove
and retain the two screws inside each bezel (see Figure 142) in
order to detach the manifold support brackets at the back of the
control panel (see Figure 143, page 83).
Figure 142: Bezel Screws Attached to Manifold Support Bracket
1 Screws (2) attached to manifold support bracket
Page 82 of 123